I have an additional question on this topic: How does the flow control to the 3pt factor into controlling the finish or use of a rear or box blade?. For proper use, the lift lever should be all the way down and the depth set with the draft lever! There are other differences! The amount of load that it takes to change the draft! I'm not up on the spec's of all the new tractors but I remember going 20 horsepower light on a demo of a 100 horse farm tractor and yet being able to out plow as our tractor only took a 7% load change to monitor it and the competition took just over 20% load change for it to move!. Takes some time and practice, and take it slow.ĭraft control is just what it says! It controls the amount of load that an implement puts on the tractor. The best way to keep your implement from raising off the ground is to give the 3pt lots of float, or lower the position past the point that you want the implement at.
Draft control changes the position of the implement to reduce the draft on the tractor, or the amount of "pull". Draft control is used to do what it says, control the draft of the tractor. Thus, what is draft control, will it do this, and if not, what is the best way? Just play with the hydraulic lift lever as I slowly move forward?ĭraft control will probably not keep your implement from rising as you describe. Essentially, I'm trying to find the best way to keep implements from rising off the ground when going over a hill or gouging the ground when I go into a dip. I'm looking at smoothing/grading soil, and was told that draft control would be something great to have for this purpose, and others tell me it would do no good (that it causes implements to hover above the ground). I asked this question in another post on a different topic, and thought it'd be better to give it its own title since I received no responses.
0 kommentar(er)
